Silence UPS alarm using apcupsd - Powered by Kayako Help Desk Software

Knowledgebase

(5)Broadband (16)Office 365 (7)Windows 10 (4)Server

Paylinks for BLOCKS

Knowledgebase

Silence UPS alarm using apcupsd Posted by Dan Mansfield on 30 January 2018 10:34 AM
Stop the apcupsd service go to command prompt cd \apcupsd\bin apctest `2012-11-18 23:30:50 apctest 3.14.8 (16 January 2010) debian` `Checking configuration ...` `Attached to driver: usb` `sharenet.type = DISABLE` `cable.type = USB_CABLE` `You are using a USB cable type, so I'm entering USB test mode` `mode.type = USB_UPS` `Setting up the port ...` `Hello, this is the apcupsd Cable Test program.` `This part of apctest is for testing USB UPSes.` `Getting UPS capabilities...SUCCESS` `Please select the function you want to perform.` `1) Test kill UPS power` `2) Perform self-test` `3) Read last self-test result` `4) View/Change battery date` `5) View manufacturing date` `6) View/Change alarm behavior` `7) View/Change sensitivity` `8) View/Change low transfer voltage` `9) View/Change high transfer voltage` `10) Perform battery calibration` `11) Test alarm` `12) View/Change self-test interval` `Q) Quit` `Select function number: 6` `Current alarm setting: ENABLED` `Press...` `E to Enable alarms` `D to Disable alarms` `Q to Quit with no changes` `Your choice: Select function: d` `New alarm setting: DISABLED` `1) Test kill UPS power` `2) Perform self-test` `3) Read last self-test result` `4) View/Change battery date` `5) View manufacturing date` `6) View/Change alarm behavior` `7) View/Change sensitivity` `8) View/Change low transfer voltage` `9) View/Change high transfer voltage` `10) Perform battery calibration` `11) Test alarm` `12) View/Change self-test interval` `Q) Quit` `Select function number: 6` `Current alarm setting: DISABLED` `Press...` `E to Enable alarms` `D to Disable alarms` `Q to Quit with no changes` `Your choice: Select function: q` `1) Test kill UPS power` `2) Perform self-test` `3) Read last self-test result` `4) View/Change battery date` `5) View manufacturing date` `6) View/Change alarm behavior` `7) View/Change sensitivity` `8) View/Change low transfer voltage` `9) View/Change high transfer voltage` `10) Perform battery calibration` `11) Test alarm` `12) View/Change self-test interval` `Q) Quit` `Select function number: q` exit then start apcupsd service again.
(0 vote(s)) Helpful Not helpful

Comments (0)

Post a new comment Reply to comment
Post a new comment Reply to comment

Full Name:
Email:
Comments:

CAPTCHA Verification
CAPTCHA Verification

Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).

Help Desk Software by Kayako

ERROR: This domain name (powertoolreview.co.uk), does not match the domain name in the license key file.

For assistance with your license, please contact the Kayako support team: https://support.kayako.com